--- xml/htdocs/doc/en/handbook/hb-install-config.xml	2005/04/07 16:12:35	1.57
+++ xml/htdocs/doc/en/handbook/hb-install-config.xml	2005/04/08 12:03:44	1.58
@@ -4,7 +4,7 @@
 <!-- The content of this document is licensed under the CC-BY-SA license -->
 <!-- See http://creativecommons.org/licenses/by-sa/1.0 -->
 
-<!-- $Header: /var/cvsroot/gentoo/xml/htdocs/doc/en/handbook/hb-install-config.xml,v 1.57 2005/04/07 16:12:35 swift Exp $ -->
+<!-- $Header: /var/cvsroot/gentoo/xml/htdocs/doc/en/handbook/hb-install-config.xml,v 1.58 2005/04/08 12:03:44 swift Exp $ -->
 
 <sections>
 
@@ -237,6 +237,8 @@
 # <i>nano -w /etc/conf.d/net</i>
 </pre>
 
+<!-- Old baselayout - current stable -->
+
 <p>
 The first variable you'll find is <c>iface_eth0</c>. It uses the following
 syntax:
@@ -288,6 +290,35 @@
 shouldn't be reproduced as you can only set one gateway per computer.
 </p>
 
+<!-- New baselayout - current testing
+
+<p>
+The first variable you'll find is called <c>config_eth0</c>. As you can probably
+imagine, this variable configured the eth0 network interface. If the interface
+needs to automatically obtain an IP through DHCP, you should set it like so:
+</p>
+
+<pre caption="Automatically obtaining an IP for eth0">
+config_eth0=( "dhcp" )
+</pre>
+
+<p>
+However, if you have to enter your own IP address, netmask and gateway, you need
+to set both <c>config_eth0</c> and <c>routes_eth0</c>:
+</p>
+
+<pre caption="Manually setting IP information for eth0">
+config_eth0=( "192.168.0.2 netmask 255.255.255.0" )
+routes_eth0=( "default gw 192.168.0.1" )
+</pre>
+
+<p>
+If you have several network interfaces repeat the above steps for 
+<c>config_eth1</c>, <c>config_eth2</c>, etc.
+</p>
+
+-->
+
 <p>
 Now save the configuration and exit to continue.
 </p>